Sponsored

Recent content by Lodans

  1. ECU module programming guide using FDRS

    Only shows GSM. That is like mine. Looks like ford updated the other "stuck" modules.
  2. ECU module programming guide using FDRS

    I live in Leander and can help, I have a forum member coming over Monday(depends on the weather) pm me if still needed.
  3. ECU module programming guide using FDRS

    You don't need it. I drove to work with BC and no activation.
  4. ECU module programming guide using FDRS

    It showed up before I received the activation notice. The option should be under features, driver assist then cruise control. See picture.
  5. ECU module programming guide using FDRS

    Sorry, busy day and did not read it fully. I hold the volume down and track forward buttons on the steering wheel for 10 seconds and it hard boots the APIM. Basically the two outer buttons on the steering wheel.
  6. ECU module programming guide using FDRS

    Do a hard reboot on the APIM. then check under driver features., there should be a Hands free driving mode.
  7. ECU module programming guide using FDRS

    Just received my activation email, so I guess I am official.
  8. ECU module programming guide using FDRS

    No, mine just started working. I checked the ford website and I am still "waiting on activation" but eveything works.
  9. ECU module programming guide using FDRS

    I had them enabled and no issues with the update, but I no longer have any of my Forscan changes including glare free. I will just redo them in a couple of days.
  10. ECU module programming guide using FDRS

    Are you doing key on engine off? If so try Key on engine on, this worked for me.
  11. ECU module programming guide using FDRS

    I was able to get all the updates to go through but still have the IPMA, PCSM, GCM and ABS module showing in the updates. I can confirm that BC is working as I used it this morning on the way into work so I think there is a bug keeping them in the list. I also have cameras in motion and the side...
  12. ECU module programming guide using FDRS

    I had the same thing happen to me. I turned off the ignition waited 3 minutes and started the truck and it came back with a success.
  13. ECU module programming guide using FDRS

    So I seem to be stuck. I did the GWM and Apim just fine. I did the ipma and power steering module but they will not go away, there are no errors or dtc's. I show hands free under the sync about but do not show it under driver features even after a hard boot. I looked at connected services and...
  14. ECU module programming guide using FDRS

    I am working on mine right now about 2 hours into the ipma. I did the ccm with no issues. Keeping my fingers crossed. I will be up all night if needed. I am now using the mongoose.




Top