Frunk Problem and Incessant Beeping

[River Rat]

Well I followed the video and removed the beeper, not as straight forward as the video but it helped. It is quiet now but throws a fault anyway so it may be another issue in the mechanism. Also found a carabiner that I hooked in the emergency loop release and that is a improvement. Dropping off for service Friday and will update.
If the wires for the beeper were extended the beeper could reside behind the lower removable panel without having to remove all the frunk components. I don't carry #45
Torx driver and 13mm , 10mm with me and Baby its cold outside.

Sponsored

 

[River Rat]

Ok, Frunck fixed I think the module had been replaced and they changed the latch too. Beeper is moved to behind the second removable panel on the left side so easy to yank out if it does it again. Bonus got my long awaited heated steering wheel and charge cord stuck reprogrammed module. module. Light bar still waiting parts and I have to use another dealer for High voltage Battery Module replacement and or BECM software update.