Frunk Problem and Incessant Beeping

[River Rat]

Well I followed the video and removed the beeper, not as straight forward as the video but it helped. It is quiet now but throws a fault anyway so it may be another issue in the mechanism. Also found a carabiner that I hooked in the emergency loop release and that is a improvement. Dropping off for service Friday and will update.
If the wires for the beeper were extended the beeper could reside behind the lower removable panel without having to remove all the frunk components. I don't carry #45
Torx driver and 13mm , 10mm with me and Baby its cold outside.

Sponsored

 

[River Rat]

Ok, Frunck fixed I think the module had been replaced and they changed the latch too. Beeper is moved to behind the second removable panel on the left side so easy to yank out if it does it again. Bonus got my long awaited heated steering wheel and charge cord stuck reprogrammed module. module. Light bar still waiting parts and I have to use another dealer for High voltage Battery Module replacement and or BECM software update.

 

[ciferguson37733]

Today: Friday 13th….
Frunk Tamper alarm started going off around midnight - truck was parked and plugged in.

I was fast asleep and did not see it until I got up for work about 3A.

By that time battery was low enough that it shut itself off (Ommu). Did not know it had that capability. But it’s good as it protects itself

Remote would not unlock (no battery power). Did the manual unlock with the key in the FOB and popped the frunk.

Hooked up a NOCO power boost I got due to recommendations here (thanks all) and brought everything back online, reset the frunk, and now all good.

Only glitch was figuring out why the battery would not keep the truck going (it had turned itself off). Once enabled - all good. Charged back up in about an hour.

Not happy about the frunk alarm running the battery down - but now I am pretty confident in the ability to recover the truck from this sort of event.

Sponsored