Search results

726-18-01 0101 0101 014B 726-24-01 0101 0101 0157 726-27-01 0101 1401 016B 726-28-01 0000 0101 0061 726-31-02 0101 0100 0063 726-45-01 0101 F401 016B

Are you 100 % sure all of you wires are in the correct pin position. i can look back and see if i can send the as built revisions i did

I actually used one of these to get the harness through under the dash and through the door jamb. It was much easier than i anticipated!

I bought both handles, the ML3Z-1522405-DCPTM is the F-150 handle but it is only available in primed not textured black. The M2DZ-7822405-CB is the bronco handle, the internals are different but the handle cover is the same. i took the primed cover off of the f-150 and swapped it with the...

If you reference earlier in the thread they show a pretty good description of how to remove the door jam housing but once you get it out and connectors disconnected you can pull the door harness into the door and out the speaker hole for easy access. The body side has about 4 inches of slack so...

No, it is tight but it is pretty easy. When you separate the connector like i have pictured below they slide right in. you have more room than you think. I then tied up the harness and ran it below the dash under the a/c evap case. Try to tie it up behind the gas pedal and above the steering...

https://1drv.ms/f/c/7fdda04432191d49/Ek6aw4A2B9pCo0s-vDW4E1QBgY6FwIH-WvbhnIxQP_gDdg?e=N6AdUx This is the firmware i got from @Jesse-Infotainment.

For anyone doing this on a 2024 xlt i just got mine completed and working. Parts you need for this project are: The harness listed Previously PL3Z-14631-G Handle listed previously ML3Z-1522405-DCPTM (includes the passive button/antenna module) I used a bronco handle and swapped covers so i...