Sponsored

Search results

  1. 7.2KW generator not able to handle a circular saw

    So it seems like the entire system is 2.4kw so even if one plug says 20amps it doesn’t mean both outlets can run 20 amps at the same time. Both plugs in the bed should run two devices up to 20amps total. You may have a separate smaller inverter under your seat. The outlets in my vehicle can...
  2. 7.2KW generator not able to handle a circular saw

    technically,120v x 10amps can handle 1200 watts, but it would make more sense if it was 20amp total in the system . Not 10 amp each plug. It’s not the constant current the appliance draws that’s usually the issue. It’s the spike at the initial turning on of the device that can spike up to 6000...
  3. 7.2KW generator not able to handle a circular saw

    Ok. I am an idiot. I didn't know you can program it, but I got it right before I had to leave town, so I only had a few minutes with it. When I get back, I'll look at it. Thank you so much for the followup. Ever grateful!
  4. 7.2KW generator not able to handle a circular saw

    I got this to test on a 2HP Air Compressor. It didn't work because the air compressor needs the spike to get the motor running. It was worth a shot though.
  5. 7.2KW generator not able to handle a circular saw

    With the advancements these days on high voltage battery tools, I Rather charge those batteries and run them independently if that makes sense for the scenarios.
  6. 2021+ F-150 FORScan List / Database / Spreadsheet ?

    Going off-roading solo quite a bit, this sucks. I’m tempted to buy a new Land Rover defender just because of this. Ford should allow this in offroad modes.
  7. Limited Lightning Tow Range

    I heard the story by a trailer manufacturer that people would show up with their Tesla and take home their trailer but didn't know their battery availability would be cut in half, so if they were farther away that 100 miles, it would take them forever to get home. And that's with a mostly empty...
  8. 7.2KW generator not able to handle a circular saw

    You may be able to get a soft start for your AC unit. Helps tremendously.
  9. 7.2KW generator not able to handle a circular saw

    With Costco just 3 miles from me... never, but I do save at the gas pump. With the 36 gallon tank, I only have to go once every few months.
  10. 7.2KW generator not able to handle a circular saw

    When trying to test air compressors with some battery generators I had, I found that the startup energy would overcome the Inverter, so it would trip the system. Those older saws may be drawing more than 5 times more electricity at startup. I have the Max Towing packaging in my platinum, but I...
  11. Audio source glitch

    Tons of sound system and CarPlay issues on our last road trips especially when other devices are hooked up. It started flaking out and freezing recently, where the only way I could use the console is to do a hard reset. Even turning off the car didn’t unfreeze the screen.
  12. Trailer Right Turn Lamp Fault

    I Started having this error show up. I had to push the 7pin from inside the bumper to get rid of it. Once in a while, it'll say Trailer disconnected, and I have to get back inside the bumper, and wiggle things around. Mine may be a different issue, but same symptoms. Very annoying.


Top