Search results

Did the alignment procedure fix the right line hugging? My truck has done that since I got it off the lot. Still does it with BC active.

Well I think I did it. I'd like to thank everyone for their input and dealing with my ignorance. I could not have gotten this far without you.

Does anyone know if there is a recommended way to verify that an update was successful or not and it is on the module proper version. Is there a table we can reference? Maybe it could show versions of a particular module.

I am in the same boat.

Anyone know how to "wake up" the truck from a failed programming? It said I had a PCM update from the ABS update. Now the truck is in the program mode but won't get out of it. Thanks much in advance

I agree with you. My first MongoosePLus I got was dead on arrival, I could see scratches on the connector. The seal looked "used". So i returned it and got a second Mongoose. This also looked used but it works, and when i tried activating it, it says it was already activated. Considering how...

just called Mongoose support and they confirmed it is a dead device. Sending it back and ordering a new one.

Yes i ran this and installed. It is during the activation stage that it says the device is not found when plugged in. It has you unplug and replug it back in in the end.

Those are the drivers for the Mongoose Pro. I have the Mongoose Plus

So anyone get an issue where the Mongoose is not recognized by your computer?

So my VXDiag Nano is already set at 9600 baud and my CCM "borked". Did you change the baud rate in Windows device manager? (Not fdrs) Or was there another location?

Yes sir

If you purchased the recommended conditioner from Amazon. I found that I had to turn it off and on by hitting the stop start button to get it to charge again. You can tell it is charging by the solid orange light and your voltage should shoot up.

I know Bob_Mac is helping me with this, but I am also getting this error when trying to update the GWM Module A. Just curious if anyone has seen this or knows anything about it.

VCX Nano

I did last night. I kept getting a 500 error

Same thing has happened to me. The CCM failed when trying to erase the blocks.

I just tried the Cruise Control Module and it failed while trying to erase blocks... Now its purple. PMI doesn't seem to help either.

OK I am getting the following error when trying to update the GWM Module A: Procedure Unsuccessful - GetConfigDataFromGIVIS Modified Configuration data is missing from Ford server Any ideas?

I saw this too, but didn't apply it yet.