Access through firewall for wiring accessories

[gmarcucio]

Has anyone installed accessories where they have run wires from the Frunk area into the interior? Did you run the wires through the firewall and if so at what location? Is there a rubber plug somewhere that I am not finding?

Sponsored

 

[Runaway Tractor]

Right side between the fender and frunk under the plastic removable cover. There is a large grommet with lots of room to poke through.

 

[gmarcucio]

Right side between the fender and frunk under the plastic removable cover. There is a large grommet with lots of room to poke through.

Thank you, I did see that on the left side. And I actually started poking there, but then stopped and decided to concentrate on where I was going to pick up my "key-on" power supply first. I found a 10A fuse #21 (spare unused) in the under hood fuse box that is switched Key-on power. I'll probably use that with a fuse tap and 5 amp fuse. Run a wire into the cab through the firewall for a switch for the lights.

 

[Storm Breaker]

what is the best way to puncture then run wires through that grommet?

 

[sr3jan]

You could also use the access port in the floor under the drivers side foot well.

 

[gmarcucio]

I used the small gromet the emergency hood cable passes through the firewall. I poked a small hole in it along side the cable.

Sponsored