Search results

I also had a powertrain malfunction/reduced power, service vehicle soon, stop safely now, pedestrian sounder fault service now, trailer brake system fault see manual, high voltage battery warning. The issue ended up being a damaged wiring harness, took few days to diagnose, few weeks wait for...

same problem

2019 Platinum….. don’t miss it at all.

i connected the LVB to a battery charger for a few hours. I followed the reset procedure. The pending update has completed overnight. This happened automatically, I still don’t have access to any type of settings within “Software Updates” to manually initiate an update. thank you for sharing...

I have tried LVB reset multiple times. . Just did it again tonight. It didn’t do anything. I am also on 3.5.4. Update pending. My software update page in the truck doesn’t have any settings for scheduling etc.….nothing. Just says that I have update pending but no way to make it happen...

same here…… no departure time set. preparing for drive changed back to charge complete 10 minutes later. Plugged in all night, set to 50%. Temps outside 0F.

How did you do your dc connections in the inverter. Did you use crimp connectors like the existing connections? If so, can you share type and source. do I need ground wire in the dc conduit ?

mine is not a fleet vehicle

I have the same problem. Tried sync reset, 12v battery disconnect, steering wheel reboot. Still do not have any settings within the software update screen. Yesterday however, I received update to 3.5.3, and then 3.5.4. Still no menus or options within software update screen.

Just received 3.5.4

Just received 3.5.3 today. Why am I so far behind.

Can you share which guide you followed please. Thanks.

I guess I’ll have to try that. Was trying to avoid redoing settings, adding Bluetooth devices again etc.

Can’t get PAAK. My update won’t complete. Shows on ford pass as “ update pending action required”. Doesn’t give any method to schedule on the app or in the truck. I have called ford OTA and they couldn’t do anything. I have done the key cycle procedure multiple times, didn’t work. I do not have...

You don’t get a detailed step by step instruction for the whole system. You just get an install document for each component.

Received rebate check today. Application was approved 09/15.

What kind of range is everyone getting........ 1100 miles done. Range calculating at 371

i took delivery on 08/07.

Software update Successful. I got instructions from Ford chat…. Same procedure that davidf01 used. First I would like to preform a Key Cycle. To perform a key cycle: 1. Power off the vehicle (remove the key from the ignition if it is not a push to start). 2. Open the driver's side door. 3...

Hi David, I tried your method twice already. No luck yet….. I’ll try again later.