Sponsored

Ford Lightning with an onboard power system that provides a 240V output, tw0 110vac 180 degree?

Devereuxstreet

New member
First Name
John
Joined
Sep 5, 2022
Threads
0
Messages
2
Reaction score
0
Location
Pittsboro
Vehicles
Tesla MYLR, Toyota Tundra
I just purchased a Ford Lightning with an onboard power system that provides a 240V output. But I will get car next week, Since my well water pump at home operates on 240V, My question is: Is the 240V live wire equivalent to 110V AC relative to ground, or can I directly send 240V to my home’s electrical system? I don't need send another cable - 120v to home again I don’t want to use Ford's Intelligent Backup Power system because it’s too expensive. I also have solar panels, a solar system, and a gas generator. But my solar diverter is 220vac. Not two 110vac, 180 degree. My goal is to disconnect from the Hydro One power grid during the summer due to high electricity transfer fees, which are 0.15/kWh and sometimes transfer fee even 0.20/kWh. Is it possible to do this?"
Sponsored

 

Effonefiddy Lightning

Well-known member
First Name
Alfred
Joined
Jun 2, 2022
Threads
2
Messages
266
Reaction score
209
Location
California
Vehicles
23 F150 Lightning SR Antimatter Blue /2023 Model Y
Occupation
Retired
Excuse me if this is redundant but I recently had a transfer switch installed with the 30A plug. If I were to cut off the ground wire from the cable to make it work with my truck, what is the danger in doing that. I've read peoples post on doing this so I just want some clarifications as to weather or not this a bad idea. Also I live in California. Not sure if other state wire home differently.
 

Runaway Tractor

Well-known member
Joined
Jan 25, 2024
Threads
13
Messages
503
Reaction score
825
Location
USA
Vehicles
Yes
Excuse me if this is redundant but I recently had a transfer switch installed with the 30A plug. If I were to cut off the ground wire from the cable to make it work with my truck, what is the danger in doing that. I've read peoples post on doing this so I just want some clarifications as to weather or not this a bad idea.
If your transfer switch also transfers the neutral, then there is no need.

If your transfer switch does not transfer the neutral, then you have the usual problem with the GFCI tripping. Lifting the ground on the house end of the cable at the generator inlet receptacle creates no danger or safety hazard. None. Zero. The only hazard is the code Nazis trying to throw books at you. Every circuit breaker, GFCI, AFCI, and other existing protection devices will all still work. There is no lost or disabled functionality that existed in the normal power configuration. The ground wire in your generator cable is intact and protecting the cable itself. Like if someone ran it over with a lawn mower or water got in it.

It doesn't meet perfect code requirements. But this is temporary, safe, emergency power.
Sponsored

 
 





Top