eefiv1
Member
- Thread starter
- #1
I just can't see to get the handsfee to work.
Thanks to all the folks on the ECR module progamming guide thread (https://www.f150gen14.com/forum/threads/ecu-module-programming-guide-using-fdrs.8249/unread) I was able to easily upgrade by Job 1 2021 F150 without much issue. Everything seems fine. Under Sync/About it shows the Handsfree valid through 10/2022. I even get prompts on the dash that Blue Cruise is available, however it never allows the handsfree option. It still requires my hands on the wheel. It does however monitor whether or not I am watching the road and warns when I do not.
At first I thought maybe for some reason the section of I65 I drive everyday was not on the approved Blue Cruise roads, but I did a trip on I64 today as well, with the same results. I have no errors, all the appropriate settings are enabled in Sync. All of the updates are applied with no issues. I have even reset Sync and FP just to rule everything out.
Any thoughts on what I might be missing?
Thanks to all the folks on the ECR module progamming guide thread (https://www.f150gen14.com/forum/threads/ecu-module-programming-guide-using-fdrs.8249/unread) I was able to easily upgrade by Job 1 2021 F150 without much issue. Everything seems fine. Under Sync/About it shows the Handsfree valid through 10/2022. I even get prompts on the dash that Blue Cruise is available, however it never allows the handsfree option. It still requires my hands on the wheel. It does however monitor whether or not I am watching the road and warns when I do not.
At first I thought maybe for some reason the section of I65 I drive everyday was not on the approved Blue Cruise roads, but I did a trip on I64 today as well, with the same results. I have no errors, all the appropriate settings are enabled in Sync. All of the updates are applied with no issues. I have even reset Sync and FP just to rule everything out.
Any thoughts on what I might be missing?
Sponsored