OP
OP
- Thread starter
- #46
Yes, all the programming is complete, now on to built status date, hopefully there isn't much of a delay, normally 7-14 days.
Sponsored
Sponsored
OP
OP
- Thread starter
- #49
Just got done looking, your codes should be posting tonight the two Rodman dealer trucks just above you were same blend day as you but 174 trucks before you, pretty certain they will wrap up this build week by Tuesday.
Subsequently, build week 10/23 will follow immediately on Wednesday and being as it's running 250 fewer trucks, it should wrap up this coming Sunday, hopefully leading to the 11/6 build week kicking off just in time, but if there is any remaining slack, their production goal was similarly compressed by another 498 trucks for a very low volume of 1019 Lightnings, ideally they will be fully in sync for build 11/13
stevey_frac
Active member
My truck has flipped over to built as of this morning. It lists yesterday as the date this happened, but I know I checked right before midnight... So I think there is some update lag in the tracking info.
Sponsored
OP
OP
- Thread starter
- #52
7-14 days to see BUILT date
1-14 days to load onto a train
14-21 days from shipped to delivered at your dealer.
OP
OP
- Thread starter
- #53
Awesome, the Rodman truck before you has as well!!!My truck has flipped over to built as of this morning. It lists yesterday as the date this happened, but I know I checked right before midnight... So I think there is some update lag in the tracking info.
They are getting into a rhythm!!
Parsnip
Member
My "in production" date was 10/25, so hopefully I will get to built tomorrow. Is anyone else not able to see the codes from the motorcraftservice site? When I try to check with my vin and order number, it just hangs.My truck has flipped over to built as of this morning. It lists yesterday as the date this happened, but I know I checked right before midnight... So I think there is some update lag in the tracking info.
stevey_frac
Active member
I don't need my order number to look at the codes. Just my VIN, and to fill out a CAPTCHA.
Interestingly.... No recalls or Customer Service Programs listed for my truck. Should I expect that to get filled in soon?
Sponsored
Parsnip
Member
You are right, I mispoke, just vin on that search, but I still don't get any data. It thinks forever and never gets to the codes page. I saw it before both with and without codes, but can't get there anymore.
stevey_frac
Active member
I just rechecked. I can still see the codes for my truck.
OP
OP
- Thread starter
- #58
Join the conversation in the 10/23 build week thread.
I looked at a 10/25 this morning no codes yet, keep watching eventually they will show.
OP
OP
- Thread starter
- #59
Hopefully your truck will be built with new version wiper motor & tailgate light bar, so no "RECALLS"
But you will eventually see a CSP for the BECM program update, ---UNLESS-- the MoCO updated the version of code loaded during production run (unlikely)
Parsnip
Member
I am actually a 10/9 build date that went into production on 10/25. I saw the codes previously but can't get to them now. I will try from home, it might be my work network.
Sponsored
