Tripping Pro Power breaker with 120v welder

[v2h8484]

The Ryobi unit probably has an inrush current limiter while Harbor Freight one probably does not and saved 10 cents in cost.

Sponsored

 

[broncoaz]

I’m hoping my new Flash can run my Miller 190 MiG welder with and without the spool gun. According to the spec sheet the welder draws 21.7 amps at 240v, so I’m hoping the 30 amp plug is enough.

https://www.millerwelds.com/-/media/9588a5f9997a4e65b132a1712eb63659.pdf

 

[Pcontrer1]

I’m hoping my new Flash can run my Miller 190 MiG welder with and without the spool gun. According to the spec sheet the welder draws 21.7 amps at 240v, so I’m hoping the 30 amp plug is enough.

https://www.millerwelds.com/-/media/9588a5f9997a4e65b132a1712eb63659.pdf

Did this welder work without tripping the propower?