Turn Signal on Camera while towing - Drive modes gone

[Martin Rebuilds]

Hi All,
Programmed the APIM and IPMA on my 23 lariat ER last week to enable the turn signal cameras while towing and it works great, expect for one problem. I noticed Saturday that the drive modes screen in the menu is gone. Something with the configuration of the 2 modules turns it off. Anyone have any ideas or has enabled this without loosing the drive mode screen.

Changes made:
APIM (7D0-02-03) to XXXX-X8XX-XX-- (have not tried C in the APIM yet)
IPMA (706-01-02) to 3XXX-XXXX-XX
I can revert back to ABD but I really like the option.
Thanks everyone.

2023 F150 Lightning Lariat ER
Tow tech package
NOT max tow
Fully updated (12/23/24 with FDRS)

Sponsored

 

[rugedraw]

Check this setting:

 

[bmwhitetx]

Changes made:
APIM (7D0-02-03) to XXXX-X8XX-XX-- (have not tried C in the APIM yet)

For 7D0-02-03, based on Livinup's spreadsheet, you want to add 8 to the previous value to enable TSV. What value did you have there before?

Looking at Lightning As-Builts, Pro XLT had 0 while Lariat have 4. So you would want a "C".

Edit: If you changed it from a 4 to an 8 you would have disabled Controls Tab.

 

[Martin Rebuilds]

For 7D0-02-03, based on Livinup's spreadsheet, you want to add 8 to the previous value to enable TSV. What value did you have there before?

Looking at Lightning As-Builts, Pro XLT had 0 while Lariat have 4. So you would want a "C".

Edit: If you changed it from a 4 to an 8 you would have disabled Controls Tab.

I will check what value I had before and play with the values in the chart. Report back soon but its 9° here today so maybe later than sooner.