Departure time enabled by itself...I am missing something?

[SSNutz]

Hello, I was wondering if any had this issue - I turn off my departure time in Ford Pass app. And then I will check the app vehicle page later and I see that I have message "Next departure is set for .." so I check the schedule and sure enough, it is enabled again. Anybody have this issue? Another place to deactivate this? It has been annoying problem and believe the reason why start climate fails.

Sponsored

 

[TaxmanHog]

Ford Pass has been slow and unreliable with editing and or deleting schemes.

Are you on the current 5.15.0 release of Ford Pass?

In the meantime delete the configurations via SYNC, Charging app, Departure Times, clear all.

 

[SSNutz]

Thanks for the reply and yes I have the latest, 5.15.0 on the Ford Pass.
Do I need to delete the configurations via SYNC, Charging app, Departure Times, clear all, thru the Truck's infotainment screen?

 

[TaxmanHog]

Thanks for the reply and yes I have the latest, 5.15.0 on the Ford Pass.
Do I need to delete the configurations via SYNC, Charging app, Departure Times, clear all, thru the Truck's infotainment screen?

In theory when everything is communicating correctly it should disappear on Fordpass and Sync, but if there is a failure to communicate, and the truck is still showing a departure program that you don't want to execute:

• Disable departure events by turning the master switch off.
• Alternatively, while the switch is on, edit & delete {clear} all schemes.

 

[SSNutz]

In theory when everything is communicating correctly it should disappear on Fordpass and Sync, but if there is a failure to communicate, and the truck is still showing a departure program that you don't want to execute:

• Disable departure events by turning the master switch off.
• Alternatively, while the switch is on, edit & delete {clear} all schemes.

I will give it a shot. Maybe this is also why I had my charging limit set at 70% (on the FordPass) but it charge over 90%.
Is there way to use do a "factory reset"? Is this advisable?

 

[TaxmanHog]

12v negative battery post disconnect / reconnect might fix the communication issues.
Search the forum for many discussion about the process.

Sponsored