Frunk opened when using keypad door unlock

[Literider150]

I went out to my garage to retrieve something from my 2024 Flash. Didn't have my key fob so I used the keypad on the driver's side door jam. BTW - I have found this keypad to be very useful. Almost didn't lease the truck cause I thought it would be useless. I use it a lot. - When truck unlocked the frunk lid opened up. I just had to push the interior button by the steering wheel to close it again.

Has anyone else had this happen to them?

Sponsored

 

[Webbo85]

The last number of your door code is the 7-8 button! You must have hit it an extra time because that will open the Frunk from the keypad if pressed within 5 seconds of entering your passcode.

 

[jetfixr1]

The last number of your door code is the 7-8 button! You must have hit it an extra time because that will open the Frunk from the keypad if pressed within 5 seconds of entering your passcode.

Didnt know that!

 

[bmwhitetx]

Didnt know that!

Using the Keyless Entry Keypad

Unlocking the Driver Door
Enter the factory-set five-digit code or your personal code. You must press each number within five seconds of each other.
Note: All doors unlock if the two-stage unlocking feature is disabled. See Keyless Entry Settings.
Unlocking All Doors
Enter the factory-set five-digit code or your personal code, then press 3-4 within five seconds.

To Release the Frunk
Enter the factory-set five-digit code or your personal code, then press 7-8 within five seconds.

Locking the Doors
Press and hold 7·8 and 9·0 at the same time with the driver door closed.
Note: You do not need to enter the code first.

 

[TaxmanHog]

Manual references

Sponsored