Stick to Rotary Shift Knob Conversion w/ 3D Printed Rotary Shifter Holder

[Drayday55]

Looks great! Did you do a non-monotonic fill pattern for the console? Looks very cool IMO

The fill is rectilinear the top layer is non monotonic

Sponsored

 

[asianman35]

I have an extra print that I'm not going to use, its the version without magsafe or anything. Ill add a few magnets in there too. Let me know if youre interested. Looking for $40 shipped to you. I'm not trying to start selling these, I just happen to have an extra, and dont want to throw it away.

 

[tnugentfl]

I have an extra print that I'm not going to use, its the version without magsafe or anything. Ill add a few magnets in there too. Let me know if youre interested. Looking for $40 shipped to you. I'm not trying to start selling these, I just happen to have an extra, and dont want to throw it away.

I'll take it! Is it complete? I have the rotary shifter on the way. What are the magnets for?

 

[asianman35]

I'll take it! Is it complete? I have the rotary shifter on the way. What are the magnets for?

Yep it's complete, I DM d you

 

[ZheWiz]

Dammit…I was too slow.

 

[Drayday55]

I just printed a second one with no cover. I made thr hole straight through the bottom so there is no need for magnets. I'll use a set screw to hold the shifter in place. If anyone wants either the first one I made ill sell it for 40 + shipping. I don't mind making them for people. It takes about 24 hours for mine to print. Just doing community service here on the forum. Not interested in going any further. I'll just sell as they come so I can keep buying filament.

 

[farmtruck]

I absolutely LOVE the final result of the rotary shift conversion in my 24 Lariat! I've seen a few different variations of this mod including cutting a hole in the dash and mounting it next to the steering wheel. I was planning on going that route but had trouble building the wiring harness. At the end of the day I'm glad I did because what I have now looks like just as OE as the dash mount, I still gain use of the workspace when in gear, the truck could be put back to original quickly and easily, the install literally too less than 20 minutes!! The first photo of the knob installed is in the raw finish how it arrives to you. I ended up hitting mine with a few coats of filler primer, doing a little sanding, and a final coat of trim black just to help it "blend in" a little. But I'm OCD like that. It totally looks good enough to run as-is.

HERE IS A LINK TO THE SHIFTER I USED. BEST PRICE I'VE FOUND ANYWHERE!

HERE'S THE LINK TO THE 3D PRINTER CUBBY/MOUNT

The mount will likely show "SOLD OUT" but just message him directly and let him know you want to be on the wait list. Ever since posting mine on a couple Facebook Groups, he's been getting slammed with orders.

Ordered mine. I don't need a 3D printer for this one.

 

[digitaldad]

I just printed a second one with no cover. I made thr hole straight through the bottom so there is no need for magnets. I'll use a set screw to hold the shifter in place. If anyone wants either the first one I made ill sell it for 40 + shipping. I don't mind making them for people. It takes about 24 hours for mine to print. Just doing community service here on the forum. Not interested in going any further. I'll just sell as they come so I can keep buying filament.

Can you let me know which version you’re offering? Feel free to DM

Sponsored