Looks like you both have MY22 trucks so I imagine Forscan doesn't have these newer calibration files loaded for this module in particular. Send a log to them and I bet they can get it added.
That is a job 2 APIM software level. You should have cams from the factory. Send me your Vin or look at your build date
@Jesse-Infotainment can you see my post a few up about my tire recalibration question?
Bed, hitch and rear cams works in motion, but I need 360 cams works also.
I purchased a Gateway 11” touchscreen laptop from Walmart for $199 specifically for the purpose of using it with FORScan.
You have a JOB 2 truck. You should have all cams in motion. Also should have cargo cam in the side stack. Plus full screen cargo cam .. I am going to look at your truck history.
Which proves that any current new X86 Intel or AMD Windows machine will work fine for FORScan. The program is communicating with the truck at very low speeds, so really any x86 windows machine should work fine.
Unfortunately I tried it. No 360 cams on motion.
https://www.motorcraftservice.com/AsBuilt
I am a ForScan newbie who has had success with most of my changes but I did not research the enable camera in motion closely and made the above updates. I have an XLT 302a WITHOUT 360 cameras so making the changes above gave me new menus camera view menus but they obviously don't work and the changes make the hard button above the screen no longer work. My camera works when I go into reverse but the button no longer works even when stopped.
I made the mistake of not backing up my files.... can someone provide me with the original as-built values for the 3 modules above? 2021 XLT 302A without 360 cams
much appreciated
Not for 21. When you change it changes online. These trucks self report. The only module that may not is the BCM all others do. Some of the other vehicles will also with sync 3 if they are on Wi-Fi or are connected.
