F-150 Lightning LED Ford Emblem Swap. Step by Step Installation DIY Video.

[butterfb]

Greenwire is intact, again the start up sequence goes and light goes on only when connecting the wire to the hot post, but when plugging it into any fuse port it will not light up at all.

how are you connecting to fuse box? Are you using the provided piggyback and plugging in both fuses. The one that came with the emblem and the one you removed from the fuse box location?
[/QUOTE]

Using piggy back with the 10 amp pulled from the fuse port that I plugged it into. Was not sent any other fuse, are two required?

Sponsored

 

[bigtomlandry]

how are you connecting to fuse box? Are you using the provided piggyback and plugging in both fuses. The one that came with the emblem and the one you removed from the fuse box location?

Using piggy back with the 10 amp pulled from the fuse port that I plugged it into. Was not sent any other fuse, are two required?
[/QUOTE]

yes. Your logo should have come with 2 5 amp fuses with the piggyback harnesses. Both ports in the piggyback harness need to be filled for it to work. One of the 5 amps with the logo and one from the one you pulled from the fuse box

 

[BennyTheBeaver]

Using piggy back with the 10 amp pulled from the fuse port that I plugged it into. Was not sent any other fuse, are two required?

Make sure the fuse for the emblem is in the right spot if there are 2 different fuses on the FuseTap (it's the fuse across from the wire coming out). The top spot with the wire coming out is for the item you're tapping and the lower spot is for the original fuse.

 

[ma0am]

Just completed my install!
Fuse 137 as someone suggested, 20A fuse on bottom, 5A fuse on top of the fuse harness. Yes, you need indeed both I guess.
And below the green hidden wire that has to be connected for the animation to be enabled.