Bluecruise 1.4 officially being sent out to F150 & Lightnings starting today (12/11/24)!

[bmwhitetx]

It took a while to pop up. I just started in Accessory mode in garage and went to the Update screen. Was still just showing 10.1.1 Complete from Dec 12. I let it sit for a minute or two and was about to turn off when the screen above popped up.

UPDATE: Ended up driving around on errands and when I got back 12V was 75%. So I clicked Install Now. Took 46 minutes with the usual buzzing bees noise. When done 12V battery was at 76%. So clearly they did change OTA functionality to allow the HVB to charge the 12V during updates. HVB went from 66.0% to 65.5%.

The official name of the OTA release is IPMA-24.204.10.9 based on release notes and follow-up survey. Sync version did not change. Only issue so far is minor - it set my radio to AM but I didn't lose presets.

Sponsored

 

[GDN]

UPDATE: Ended up driving around on errands and when I got back 12V was 75%. So I clicked Install Now. Took 46 minutes with the usual buzzing bees noise. When done 12V battery was at 76%. So clearly they did change OTA functionality to allow the HVB to charge the 12V during updates. HVB went from 66.0% to 65.5%.

The official name of the OTA release is IPMA-24.204.10.9 based on release notes and follow-up survey. Sync version did not change. Only issue so far is minor - it set my radio to AM but I didn't lose presets.

I've got carscanner, but have not checked my 12v. I started in the garage earlier around 1 and no luck. Ran an errand about 2 and no luck after 2 starts. Will get out for dinner in a bit, will see if that will trigger. I'm usually right up front with you and others.

The 12v situation has never delayed a download if I recall. That was just an impact for installing.

 

[TaxmanHog]

The 12v situation has never delayed a download if I recall. That was just an impact for installing.

Downloading happens when the maker wills it so, pull up seat on the second stringer bench Greg!

 

[mrau]

Finger tapping can't hurt.

 

[bmwhitetx]

I've got carscanner, but have not checked my 12v. I started in the garage earlier around 1 and no luck. Ran an errand about 2 and no luck after 2 starts. Will get out for dinner in a bit, will see if that will trigger. I'm usually right up front with you and others.

The 12v situation has never delayed a download if I recall. That was just an impact for installing.

Yes I agree on the 12v. I got the downloading message when 12v was 57%. But decided not to do an install at the time. But then changed my mind after some driving!

Did you get 10.1.0 and 10.1.1 plus getting the front sensor CSP? Not sure if the CSP is needed since this OTA updates the same modules. But 10.1's may be needed. One was GWM, the other was generic connectivity IIRC. And Karaoke

Sponsored