ECU module programming guide using FDRS

[Mike G]

I’ve got 1.4 on my 23 and I don’t get any text on lane changes at all. It does auto lane change with the turn signal but other than that there is no indication.

So you don't see a little animated line showing the lane change as it happens either?

I get a little text "subtitle" that says it's preparing to change lanes, or changing, or whatever, but no animations.

Sponsored

 

[astrand1]

So you don't see a little animated line showing the lane change as it happens either?

I get a little text "subtitle" that says it's preparing to change lanes, or changing, or whatever, but no animations.

Nope I get nothing at all. Now I’ve had 1.4 for a couple months now. Rugedraw helped me with that. So maybe it’s possible that I don’t have something configured just right. I’ve an ipma update available which I need to go out and do and then I’ll see if that changes anything.

 

[rugedraw]

Nope I get nothing at all. Now I’ve had 1.4 for a couple months now. Rugedraw helped me with that. So maybe it’s possible that I don’t have something configured just right. I’ve an ipma update available which I need to go out and do and then I’ll see if that changes anything.

Did you ever get the 6.8.0 OTA (or did you do an IPC update with FDRS)? DO you have the HVB % on your IPC?

 

[astrand1]

Did you ever get the 6.8.0 OTA (or did you do an IPC update with FDRS)? DO you have the HVB % on your IPC?

I never seem to get OTA’s but that’s probably because I’m updating with fdrs. But yes I do that the batt. % on the ipc. I have an ipma update available on fdrs. Can you look and see if it’s showing as a pending ota just for Curiosity as I’ll probably just do it with fdrs at some point. thanks bro!

1FTVW1EV4PWG30349

Sponsored