You know they have WiFi on cruises? You could just sit by the pool with a drink and post and check VINs stillIn between my full-time job at the dealer, and my part-time pro bono job on the forums, I would say it is well deserved.
I could, but I told my seedlings that nobody was getting internet including me and I'm sticking to it.
We hope you are right about that. 6.14 from the Mach E should truly hit the Lightnings in the next week. It will still be interesting to see when we get BC 1.4. Maybe they also want us to get that brand new Battery Optimization release first. If they'd get those 3 out to us it will be a nice level up place for all trucks.
There have been several updates that have done that. The Mach-E community is seeing that now on a DSP update.
Thank you. I've tried installing it at least 5 times. I have AM radio, not sure what to do.
Well you can either ignore it, or if you're determined, you can try a PMI to force it to update. When doing the PMI just answer "No" to the question when FDRS asks if the original module is still installed. You'll get a fresh software download that way.
Setup your rig as normal to do an update.
Thank you, I will give this a go!Setup your rig as normal to do an update.
Then after viewing and clearing any current CMDTCs, go to the toolbox tab, (see below).
To find the module you want to work on you can do it the long way, which is scrolling through the list under the "All" tab...or you can type it in to the search box like I did to limit the view to just things you can do with the ACM...or you can just pick the ACM module from the panel on the left side, and it will restrict what you see on the right side to things that only apply to that module as well.
Select the PMI option to download and then "Run" and follow the instructions. That's pretty much it.
No luck, update still shows up. Do I possibly have a bad module?Setup your rig as normal to do an update.
Then after viewing and clearing any current CMDTCs, go to the toolbox tab, (see below).
To find the module you want to work on you can do it the long way, which is scrolling through the list under the "All" tab...or you can type it in to the search box like I did to limit the view to just things you can do with the ACM...or you can just pick the ACM module from the panel on the left side, and it will restrict what you see on the right side to things that only apply to that module as well.
Select the PMI option to download and then "Run" and follow the instructions. That's pretty much it.
It's more likely it's a bad update they pushed out. If the radio is working fine I'd let it go. When they figure out the update is bad (after lots of feedback from the field) they will pull it and re-release later.
I don't have access to FDRS at the time, but this is what PTS is showing pending for you:
